Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

How do i Enable traffic shaping for inbound traffic on an interface?

traffic-shape rate bit-rate [burst-size

[excess-burst-size]] command only Enable traffic shaping for outbound traffic on an interface. How do i Enable traffic shaping for inbound traffic on an interface?

Jimjames

1 REPLY
Silver

Re: How do i Enable traffic shaping for inbound traffic on an in

Hello Jim,

The answer is that you can't. Shaping is supported in outbound direction only.

What you can do is police inbound traffic.

This can be accomplished with either MQC or CAR.

Please use the documentation:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cg/hqos_c/part20/index.htm

HTH

Leon

* Please rate posts

166
Views
0
Helpful
1
Replies
CreatePlease to create content