Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

how do I set the time interval for FRTS?

I need to set FRTS with a cir of 128k but I need to lower the time interval to the minimum, I think is 150ms, any help plese?

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: how do I set the time interval for FRTS?

10ms is the smallest interval. the default is 150ms.

Bc = Tc * cir

Just don't use the command for tc under the map-class because that's not the way to set a specific interval.

Use the formula and then configure the cir and the Bc

5 REPLIES
Hall of Fame Super Bronze

Re: how do I set the time interval for FRTS?

The lowest time interval is 10ms and you can achieve it with the following formula:

Tc = Bc / CIR

map-class frame-relay FRTS

frame-relay cir 128000

frame-relay bc 1280

This will provide a 10ms Tc.

HTH,

__

Edison.

Cisco Employee

Re: how do I set the time interval for FRTS?

Hi Joseph,

The lowest Tc is 10ms. When you are configuring map-class for FRTS, the router will calculate Tc when you configured the CIR and Bc. You can use this formular to calculate Bc

CIR = Bc / Tc , where Tc is in second

Tc = 10/1000 = 0.01

128000 = Bc / 0.01

Bc = 128000 x 0.01 = 1280

map-class frame-relay FRTS

frame-relay cir 128000

frame-relay bc 1280

interface Serial0/0/0.203 point-to-point

ip address x.x.x.x 255.255.255.0

frame-relay interface-dlci 203

class FRTS

interface Serial0/0/0

no ip address

encapsulation frame-relay

frame-relay traffic-shaping

sh traffic-shape

...snip...

Interface Se0/0/0.203

Access Target Byte Sustain Excess Interval Increment Adapt

VC List Rate Limit bits/int bits/int (ms) (bytes) Active

203 128000 160 1280 0 10 160 -

HTH,

jerry

Silver

Re: how do I set the time interval for FRTS?

10ms is the smallest interval. the default is 150ms.

Bc = Tc * cir

Just don't use the command for tc under the map-class because that's not the way to set a specific interval.

Use the formula and then configure the cir and the Bc

New Member

Re: how do I set the time interval for FRTS?

Great help, thanks

I was trying to use

SWRg1(config-map-class)#frame-relay tc 10 ?

but it never worked, now I know why

Cisco Employee

Re: how do I set the time interval for FRTS?

BTW, default CIR is not 150ms, it is 125ms or 1/8 second.

Regards,

jerry

208
Views
15
Helpful
5
Replies
CreatePlease to create content