Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How do you disable a NVIO interface?

We recently upgraded to IOS c2801-ipbasek9-mz.124-8c.bin

It created an interface NVIO. Is there a way do this?

thanks

NVI0 is up, line protocol is up

Hardware is NVI

Interface is unnumbered. Using address of NVI0 (0.0.0.0)

MTU 1514 bytes, BW 10000000 Kbit, DLY 0 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation UNKNOWN, loopback not set

Last input never, output never, output hang never

Last clearing of "show interface" counters never

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

0 packets input, 0 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

0 packets output, 0 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 output buffer failures, 0 output buffers swapped ou

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Bronze

Re: How do you disable a NVIO interface?

1 REPLY
Hall of Fame Super Bronze

Re: How do you disable a NVIO interface?

2771
Views
0
Helpful
1
Replies