06-28-2010 06:31 AM - edited 03-04-2019 08:54 AM
We are connecting our remote sites via two T1 lines from the same carrier and using Cisco router 2901's with the wan cards VWIC-2MFT-T1/E1. We would like to bundle two T1 lines to increase bandwitch.
thanks,
alison
06-28-2010 06:47 AM
hi
the best and the easiest way is to create ppp multilink bundle. this is a logical interface and the the physical interfaces will be part of the logical bundle.
you will assign the ip address to the logical interface rather than the individual physical interface.
you need to make sure that you are configuring the same at the remote end as well.
hope this helps..
http://blogs.techrepublic.com.com/networking/?p=498
regds
06-28-2010 06:47 AM
Use multilink.
06-28-2010 06:49 AM
Assuming you have 2 x dedicated T1.
HTH,
jerry
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: