Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to bundle two T1 lines in 2901 routers?

We are connecting our remote sites via two T1 lines from the same carrier and using Cisco router 2901's with the wan cards VWIC-2MFT-T1/E1. We would like to bundle two T1 lines to increase bandwitch.

thanks,

alison

Everyone's tags (2)
3 REPLIES

Re: How to bundle two T1 lines in 2901 routers?

hi

the best and the easiest way is to create ppp multilink bundle. this is a logical interface and the the physical interfaces will be part of the logical bundle.

you will assign the ip address to the logical interface rather than the individual physical interface.

you need to make sure that you are configuring the same at the remote end as well.

hope this helps..

http://blogs.techrepublic.com.com/networking/?p=498

regds

New Member

Re: How to bundle two T1 lines in 2901 routers?

Use multilink.

Cisco Employee

Re: How to bundle two T1 lines in 2901 routers?

2907
Views
0
Helpful
3
Replies