You need to consider the concurrency usage ratio in your local lan based on which you can determine the bandwidth to be subscribed from your SP..
You also need to check out whether upload or the download traffic will be there if in case if you are going for Asymmetrical line..
Best practice also would be to subscribe for lesser bandwidth for short duration and observe the peak/average usage on the links and based on that you can decide the actual bandwidth requirement for your facility..
There are other factors like latency which you may look in if you are establishing some kinda ipsec tunnels over the bandwidth that too again will consume bandwidth.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...