Re: How to cater for Channelized E3 in Cisco 3845router??
I dont think we have a Channelized option with 38xx
What we do in our case is to tell the ISP to give us an ethernet handoff (EoSDH). The SP in this case places a mux and rate limits the traffic on their port and runs a normal fiber to their backbone. We shape the egress traffic towards the SP on our router port.
Not sure whether the above procedure will help in your case though
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...