Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

How To change IP on a LOOPBACK

Hello All,

As the heading says

I am looking to change the IP on one of my loopbacks

Current Settings :

interface Loopback4

ip address 206.186.192.209 255.255.255.255

Desired Setting :

I need to change the Ip to 206.186.197.134/32  on the above mentioned loopback.

Can any of you please suggest the simplicit way to do that. Also will this cause any disaruption in service.

Thanks in advance,

Soofi!

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: How To change IP on a LOOPBACK

soofiahtesham wrote:

Hello All,

As the heading says

I am looking to change the IP on one of my loopbacks

Current Settings :

interface Loopback4

ip address 206.186.192.209 255.255.255.255

Desired Setting :

I need to change the Ip to 206.186.197.134/32  on the above mentioned loopback.

Can any of you please suggest the simplicit way to do that. Also will this cause any disaruption in service.

Thanks in advance,

Soofi!

router(config)# int loopback 4

routerconfig-if)# ip address 206.186.197.134 255.255.255.255

as for disruption depends on what it is used for. Also bear in mind if you are advertising this loopback into a routing protocol you may need to add the new IP under your router config.

Jon

3 REPLIES
Hall of Fame Super Blue

Re: How To change IP on a LOOPBACK

soofiahtesham wrote:

Hello All,

As the heading says

I am looking to change the IP on one of my loopbacks

Current Settings :

interface Loopback4

ip address 206.186.192.209 255.255.255.255

Desired Setting :

I need to change the Ip to 206.186.197.134/32  on the above mentioned loopback.

Can any of you please suggest the simplicit way to do that. Also will this cause any disaruption in service.

Thanks in advance,

Soofi!

router(config)# int loopback 4

routerconfig-if)# ip address 206.186.197.134 255.255.255.255

as for disruption depends on what it is used for. Also bear in mind if you are advertising this loopback into a routing protocol you may need to add the new IP under your router config.

Jon

New Member

Re: How To change IP on a LOOPBACK

Hi

Simply writing  a ip configuration commads for any interface of router.

Router>en

Router#conf t

Router(Config)#int loopback4

Router(Config-if)#ip address

Router(Config-if)#no shut

this will configure any loopback ip at any point of time.

Regards

Vinod Agrahari

Hall of Fame Super Blue

Re: How To change IP on a LOOPBACK

vinod.agrahari wrote:

Hi

Simply writing  a ip configuration commads for any interface of router.

Router>en

Router#conf t

Router(Config)#int loopback4

Router(Config-if)#ip address

Router(Config-if)#no shut

this will configure any loopback ip at any point of time.

Regards

Vinod Agrahari

removed

236
Views
0
Helpful
3
Replies
CreatePlease to create content