Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k

How to check Bandwidth Utilization

one of P2P link  bandwidth was fully utilizing.. I need to check the Bandwidth utilization Application wise is it Possible on router or any other tool required to the same, if so could u explain about the tool.

5 REPLIES
Hall of Fame Super Gold

How to check Bandwidth Utilization

What is the bandwidth of the WAN link?

Post the output to the command "sh interface ".

How to check Bandwidth Utilization

The Bandwith of link is 25 Mbps. I am checking through Sh int summary. utilization showing 25 Mbps.

Hall of Fame Super Gold

How to check Bandwidth Utilization

I am checking through Sh int  summary. utilization showing 25 Mbps.

Post it.  There's something I'm looking for.

How to check Bandwidth Utilization

SWTCORP01#sh interfaces gigabitEthernet 1/43 summary

*: interface is up
  IHQ: pkts in input hold queue     IQD: pkts dropped from input queue
  OHQ: pkts in output hold queue    OQD: pkts dropped from output queue
  RXBS: rx rate (bits/sec)          RXPS: rx rate (pkts/sec)
  TXBS: tx rate (bits/sec)          TXPS: tx rate (pkts/sec)
  TRTL: throttle count

  Interface               IHQ   IQD  OHQ   OQD  RXBS RXPS  TXBS TXPS TRTL
-------------------------------------------------------------------------
* GigabitEthernet1/43      0     0    0     0 27643000  2281 533000  1039   

But My question is how to check the traffic application wise?

Hall of Fame Super Gold

How to check Bandwidth Utilization

But My question is how to check the traffic application wise?

Application?  You want to check which application is chewing the bandwidth?

It will depend if your router or firewall or wireless LAN controller will support Application Visibility and Control (AVC).

17931
Views
0
Helpful
5
Replies
CreatePlease to create content