Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

how to config Aironet series 1000

Hi, after a hard work of searching, im here asking for your calificated help. I've an Aironet AP-1010 access point but it seems to be pre-configurated by the people who last used it. I need restore it to original configurations and then set it up.

Thanks

1 REPLY
Hall of Fame Super Gold

Re: how to config Aironet series 1000

I don't think you can configure an AP 1000 for Autonomous "All the 1000 Series APs support only LWAPP." (http://www.cisco.com/en/US/products/hw/wireless/ps430/products_qanda_item09186a00806a4da3.shtml)

However, if you want to perform password-recovery, follow the procedures below:

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_password_recovery09186a00800949d0.shtml

Hope this helps.

205
Views
0
Helpful
1
Replies