To keep things simple u can put 2 static routes with just their outgoing interfaces for the same destination. This will do loadbalancing + failover. This may not work if you have Ethernet presentation as WAN link..
following the approach from the previous post the config could look like this (you have to adjust interface names and IP addresses to your environment):
description to ISP1
ip address 220.127.116.11 255.255.255.252
description to ISP2
ip address 18.104.22.168 255.255.255.252
ip route 0.0.0.0 0.0.0.0 22.214.171.124
ip route 0.0.0.0 0.0.0.0 126.96.36.199
Also be advised, that this only takes care about IP routing, but NOT about security - in fact there are no security filters in place at all.
Things get a lot more complicated in case you need NAT, because you do not have your own IP address range. So the question is: do you have your own IP addresses or do you get your official IPs from the respective ISPs?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.