Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to configure 1SHDSL on 2811

I'm sorry if this question is a bit basic, but this is my first experience both with Cisco kit and with trying to find answers on their website. I have spent some hours trying to find the answer on my own, but either I'm having a bad day or it's really not that obvious.

I have a 2811 router and four 1SHDSL v3 interface cards, intended to provide a single bonded ADSL service - we're a long way from the local telephone switch, so the lines don't get faster than 2 Mb on a good day.

I can't work out how to make the 2811 see the interface cards. It's running IOS version 12.4(3h). The set of instructions for configuring the interface card (http://www.cisco.com/en/US/products/ps6441/products_feature_guide09186a008054ed9a.html) stop working at the # interface atm 0/0/0 command, as the atm instruction is not recognised.

Any clues would be appreciated.

Crac

1 REPLY
Hall of Fame Super Gold

Re: How to configure 1SHDSL on 2811

Hi,

please upgrade IOS first, what you have is too old for a new card;

http://cisco.com/en/US/products/ps5949/products_qanda_item0900aecd80591ff1.shtml

Hope this helps, please rate post if it does!

104
Views
0
Helpful
1
Replies