Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

how to configure 2 bundl's over E1

hi i need to know how can i configure 2 bundle's , i have 2 interface mulrilink over E1 and i get the error

Dec 1 17:10:41.471: %LINK-3-UPDOWN: Interface Multilink2, changed state to down

Dec 1 17:10:41.471: Se3/2:0 MLP: Request add link to bundle

Dec 1 17:10:41.471: Se3/2:0 MLP: Adding link to bundle

Dec 1 17:10:41.471: Se3/2:0 MLP: Bundle R1 in different multilink group

Dec 1 17:10:41.471: Se3/2:0 MLP: Link not added to bundle

Dec 1 17:10:42.467: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial3/2:0, changed state to down^Z

regards

  • WAN Routing and Switching
5 REPLIES
Silver

Re: how to configure 2 bundl's over E1

I doubt if you can add the same interface to 2 Different Multilink. What exactly are you looking for ? Maybe Multilink Frame Relay may solve your issue if you are looking to Seperate traffic logically.

New Member

Re: how to configure 2 bundl's over E1

no i have 2 couple interfaces and i need 1 multilink each .

Silver

Re: how to configure 2 bundl's over E1

Ok that is possible to do. There is no problem in that. Can you set pp chap hostname on all the links in the bundle and shut and no shut the bundle once and see if it comes up

New Member

Re: how to configure 2 bundl's over E1

yep i do it and steel the same :(

let me remind u that i need two multilink over 2 serial from 1 router to another one ...

when i do shut to one interface it's work but both interface multilink it doesnt work.

regards

Silver

Re: how to configure 2 bundl's over E1

Can you paste from both ends ? It may be helpful.

96
Views
0
Helpful
5
Replies
This widget could not be displayed.