Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

how to configure 3 VWIC2-1 MFT E1 card

Dear All,

              I having problem to configure E1 card (VWIC2-1 MFT E1 ) to get aggregate Bandwidth.can anybody tell that how to configure 3 E1 card in a router to get 6 Mbps bandwidth as one E1 support 2 Mbps bandwidth.Please need you assistance on this issue.I am not able to finish the project with this configuration.

I am keenly waiting for your valuable help.

Thanks and regards..

Erfan

5 REPLIES
New Member

Re: how to configure 3 VWIC2-1 MFT E1 card

Hi Erfan

You have an option of creating a MLPPP bundle on the router and you can use 3E1 for that

thxz...

Manish

New Member

Re: how to configure 3 VWIC2-1 MFT E1 card

Hi Manish,

               Thanks for your prompt support.Can you tell me any documents for this configuration.

I am keenly waiting for your reply.

Thanks and regards...

Erfan

New Member

Re: how to configure 3 VWIC2-1 MFT E1 card

pls find the attached doc may be it will help you.

brgds...

Manish

Re: how to configure 3 VWIC2-1 MFT E1 card

This is a simple config. Just remove all layer 3 config from the serial interfaces and do this

interface multilink 1

ip address 192.168.1.1 255.255.255.0

encap ppp

ppp mul

ppp mul group 1

!

int serial 1/0:0

encap ppp

ppp mul

ppp mul group 1

!

int serial 1/1:0

encap ppp

ppp mul

ppp mul group 1

!

int serial 2/0:0

encap ppp

ppp mul

ppp mul group 1

Configure all the serial interfaces identically and have the Layer 3 config on the multilink interface. Do the same on the other end.

New Member

Re: how to configure 3 VWIC2-1 MFT E1 card

Hi Ronit,

             Thanks for your reply and help.I will configure  accordingly.I will let you know if i face any problem.

Thanks and regards...

Erfan

361
Views
0
Helpful
5
Replies