Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

How to configure ADSL connection on WIC-1SHDSL Interface Card

Hi,

I have a Cisco 1841 router and one WIC-1SHDSL Card. We have ADSL internet connection though ISP but i am unable to connect using this card. What i believe is that this WIC does not supports ADSL/ADSL2/ADSL2+ connection types. Below is my configuration.

!

controller DSL 0/0/0

line-mode 2-wire line-zero

line-rate auto

!

interface FastEthernet 0/0

ip add 195.xxx.xxx.xxx 255.255.255.248 - Public IP

ip add 192.168.92.1 255.255.2550 secondary

ip nat inside

no shutdown

!

interface ATM0/0/0

no ip address

no atm ilmi-keepalivies

!

interface ATM0/0/0.1 point-to-point

ip add 172.16.66.84 255.255.255.252

ip nat outside

pvc 8/80

     encapsulation aal5snap

!

ip nat inside source list 1 interface FastEthernet 0/0 overload

!

ip route 0.0.0.0 0.0.0.0 172.16.66.83

!

access-list 1 permit 192.168.92.0 0.0.0.255

!

My ISP said that your WIC is not support ADSL/ADSL2/ADSL2+

2 REPLIES
Hall of Fame Super Silver

Hello Shareef,your guess is

Hello Shareef,

your guess is correct

 

>>>What i believe is that this WIC does not supports ADSL/ADSL2/ADSL2+ 

 

SHDSL is a different type of DSL with symmetric upstream/downstream rates and it can not be used over an ADSL* line as you have tested.

 

Hope to help

Giuseppe

 

Hall of Fame Super Gold

Where have you been Giuseppe?

Where have you been Giuseppe???

 

Haven't seen you post lately.  

210
Views
0
Helpful
2
Replies