How to configure and manage a NM-16ESW-1GIG inserted in Cisco 3925?
What is the process for managing a NM-16ESW-1GIG module inserted in a Cisco ISR2 3925 Router? I could setup the switch through the CLI, but would like to activate the Gig port and perform some other modifications. If I’m not wrong I need to activate a connection to the NM-16ESW-1GIG for getting a direct access to it. How should I proceed? Thanks.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...