Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

how to configure e1 in a lab enviroment

hello all

i have a query regarding configuring E1 on cisco 2811 that how can i configure E1 for the lab enviroment.using two c2811 routers with VWIC-2MFT-703.i want to connect them back to back.what the cabling scheme should i

adopt.and what would be the base confiurations.So the controller would be in an UP state.an early help would be highly appreciated.

1 REPLY

Re: how to configure e1 in a lab enviroment

Hi Kamran

AFAIK you get the signals on 1,2 & 4,5 pairs.

Keep normal 1,2 & 4,5 on one side and just try to reverse the same on the other side and check out ..

regds

168
Views
0
Helpful
1
Replies
CreatePlease to create content