How to configure load balancing on cisco 6509 switch between two different ISP P2P link
We have two 100 MBPS P2P link from two different ISP and we have terminated both the link on our 6509 switch. Now we want to configure the load balancing between these two disfferent ISP 100 MBPS P2P link.
So, how to go and what all options we can try ? We are thinking for Ether Channel configuration. Need your expert opinions on the same and if etherchannel configuration is the option then what would be the configuration for the same ?
How to configure load balancing on cisco 6509 switch between two
Thanks for your information.
FYI, both the linkn has been terminated on the same device only at remote end only as we are managing the remote end as well. Also, it is completely a L2 path.
So, we have hard coded 100 MBPS full duplex both end for both the ISP and when we put those ISP link on trunk at a time it is working fine abd so far we are able to spna all our VLAN from our side to remote end.
Now waht we want is to bundle both the link so that we can get 200 mbps pipe and as well as load balancing should happen.
Kindly, let me know if you need any further information from my side.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.