How to configure PPPoE authentication on the Ethernet switch of a Cisco877
i have a cisco 877 for Internet Access.
This router should negotiate it's IP via PPPOE on one of the Ethernet interfaces.
Now to my question:
1. is it possible to configure PPPoE in one of the switching interfaces?
2. If yes, how do we configure a dialer profile to act on one of the switching interfaces fa0
3. What is wrong, if the following message occurs:
Feb 11 13:44:41.478: Di1 DDR: Cannot place call, no dialer string set Feb 11 13:44:45.397: Di1 DDR: Cannot place call, no dialer string set Feb 11 13:44:46.441: Di1 DDR: Cannot place call, no dialer string set Feb 11 13:44:50.104: Di1 DDR: Cannot place call, no dialer string set Feb 11 13:44:50.872: Di1 DDR: Cannot place call, no dialer string set Feb 11 13:44:54.495: Di1 DDR: Cannot place call, no dialer string set Feb 11 13:44:55.742: Di1 DDR: Cannot place call, no dialer string set
here the config:
interface Vlan99 description Internet Access no ip address no ip redirects no ip proxy-arp ip nat outside ip virtual-reassembly crypto map FESTO ! interface Dialer1 mtu 1492 ip address negotiated ip nat outside ip virtual-reassembly encapsulation ppp dialer pool 1 dialer-group 1 ppp authentication pap chap callin ppp chap hostname cnx-XXXXXXXXXX@cetus ppp chap password 0 XXXXXXXXXXXXXX ppp pap sent-username cnx-XXXXXXXXXXX@cetus password 0 XXXXXXXXXXX crypto map FESTO
interface FastEthernet0 description Internet Access switchport access vlan 99 pppoe enable group global pppoe-client dial-pool-number 1
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...