Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to configure rate limit in catalyst 2960

Hello,

We have Catalyst 2960, we must limit the input output interfaces at a constant rate (eg 40Mb / s). rate-limit function is not currently supported, is what you intend to change the ios for the function is supported?

if not, how I can do to meet this need?


thank you for your reply

2 REPLIES
Hall of Fame Super Silver

Re: How to configure rate limit in catalyst 2960

hello David,

by using QoS you can  limit outbound

see

http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/12.2_53_se/configuration/guide/swqos.html#wp1253412

This example shows how to limit the bandwidth on a port to 80 percent:

Switch(config)# interface gigabitethernet0/1
Switch(config-if)# srr-queue bandwidth limit 80

I'm afraid nothing can be done for inbound

Hope to help
Giuseppe

New Member

Re: How to configure rate limit in catalyst 2960

Hi,

    Agreed to above answer. For more information Plz vist : http://startnetworks.blogspot.com/2010/08/rate-limit-on-switches.html

Here you can find with examples and some more ways.

Do rate for helpful posts...

Uttam

http://startnetworks.blogspot.com/

2295
Views
0
Helpful
2
Replies
CreatePlease login to create content