Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to configure route-maps on hsrp enabled interfaces??

Hi,

I would like to know how to configure Route-maps on hsrp enabled interfaces??

Thanks,

Syed

3 REPLIES
Cisco Employee

Re: How to configure route-maps on hsrp enabled interfaces??

hey Syed,

What is your objective to do this. Normally you should be able to do this. What IOS and platfrom you are using?

Parikshit

New Member

Re: How to configure route-maps on hsrp enabled interfaces??

Objective is to apply a route-map to an interface on which hsrp is enabled..

As you know that HSRP would require two interfaces one in Active and the other standby so I was doubtful about the application of route-maps in such a scenarion.

Although it is true that I might have to apply the same route-map on both the Active & Standby interfaces but wanted to confirm whether this action would be correct from the experts on this community.

Waiting for your reply.

Regards,

Syed

Cisco Employee

Re: How to configure route-maps on hsrp enabled interfaces??

Well... genrally HSRP peers should have same config so that HSRP is transparent to other devices so your action plan is correct.

You have to apply route map on both to sustain the transparency.

HTH

Parikshit

191
Views
0
Helpful
3
Replies
CreatePlease login to create content