Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How-to configure Sup2T management ports in a dual-sup chassis?

Hi,

We've just invested in a pair of Sup2Ts to upgrade a Sup720 6509 chassis but I'm unsure exactly how the management port(s), aka the

Connectivity Management Processor (CMP), should be configured (and patched) in a dual supervisor system?

Is each CMP an independent entity or is the management interface configuration (IP address, gateway, etc) replicated between supervisors?

If it's the latter then do both management ports need to be physically connected at the same time?

Thanks in advance

Matthew

Everyone's tags (5)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Bronze

How-to configure Sup2T management ports in a dual-sup chassis?

CMP should be treated as a separate entity and there is no replication of such information between supervisors.

For more information, please refer to the documentation:

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/cmp_configuration/guide/cmp_overview.html

1 REPLY
Hall of Fame Super Bronze

How-to configure Sup2T management ports in a dual-sup chassis?

CMP should be treated as a separate entity and there is no replication of such information between supervisors.

For more information, please refer to the documentation:

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/cmp_configuration/guide/cmp_overview.html

6549
Views
0
Helpful
1
Replies