How to connect remote router 1811 with new router 2811?
There is a new purchase request on this new 2811 router. This router will link up with a remote 1811 router, located in other country. Other modules, such as, 1 two-port voice interface card - FXS and DID, and 32-channel packet voice/fax DSP module are purchased well. If I were not wrong, the purchase also includes 4HWICs, 2PVDMs, 2AIM. What are they?
I have a discussion with my boss. The remote router 1811 will connect with router 2811 thru one WAN port, voice/fax also piggyback on this router as well. My main concern is how can I configure Voice/fax? If possible, pls provide me a typical scenario configuration.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...