The network consists of dual 6500 series catalysts servicing as core switches/routers. Attached to the core are two 3700 catalysts operating as access layer devices with both layer-2 and layer-3 interfaces, and a single 7600 series router as the network edge. The 7600 series router is running BGP and OSPF. The core switches are running OSPF and the access switches are not running a routing protocol. This network has no packet filtering of any kind. How you would design secure routing for this network.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...