Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to do Bandwidth Sharing

I have installed ASA 5520 firewall and 1841 Cisco router. firewall is connected to internet and the router. Router is connected to Network. There two networks available. I have completed the configuration. but problems. i dont know how to do the bandwith sharing for these networks.

In the router i created the policy-map and assign the bandwidth percent command. but it cann't apply for the sub interfaces. please any help please finish this configuration.

Thanks

Huzair

Everyone's tags (1)
2 REPLIES
Bronze

Re: How to do Bandwidth Sharing

You can't apply a service policy with queueing in the parent policy to a subinterface, but child policies are fair game for queueing as long as you have shaping on the parent policy.

So something like this (you might not want these exact parameters, but it gives you an idea):

policy-map PARENT

class class-default

  shape average percent 100

  service-policy out CHILD

!

policy-map CHILD

class VOICE

  priority percent 10

!

interface GigabitEthernet 0/0.1

service-policy out PARENT

http://www.cisco.com/en/US/tech/tk543/tk545/technologies_tech_note09186a0080114326.shtml

New Member

How to do Bandwidth Sharing

Hi Mohamed,

You want to do this sharing at 1841? between what internet and other network?Can u tel how ur setup is? any diagram to understand better.

Regards,

Satya.M

410
Views
0
Helpful
2
Replies
CreatePlease to create content