I have a primary site with private connection via MPLS and then I have a cable modem connection. Right now we use 2801 router for primary connection and pix 501 for backup connection via VPN. The fail over is not automatic. Anything I can do?
i think you can usw HSRP for the local fail over. You should use the MPLS VPN connection for primary usage (do you use dynamic routing protocols in your MPLS VPN?) and also a dynamic routing protocol between the 2801 and the pix. (i hop the pix support it ... i have'nt use the pix at this moment).
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...