Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
255
Views
0
Helpful
1
Replies

How to enable SSH nad nating at the same time

hassan.saleh
Level 1
Level 1

‎10-11-2009 02:08 AM - edited ‎03-04-2019 06:19 AM

Dears,

The problem is i have a static ip on router interface and it is configured for pating.

But i can't ssh to the public ip address unless i remove the IP nat outside on the wan interface.

Is there a solution to this issue?

Labels:
0 Helpful
1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

‎10-11-2009 03:09 AM

Please check the ACL used in "ip nat inside source" command. If it contains "any", that is the cause.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card