Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to enable SSH nad nating at the same time

Dears,

The problem is i have a static ip on router interface and it is configured for pating.

But i can't ssh to the public ip address unless i remove the IP nat outside on the wan interface.

Is there a solution to this issue?

1 REPLY
Hall of Fame Super Gold

Re: How to enable SSH nad nating at the same time

Please check the ACL used in "ip nat inside source" command. If it contains "any", that is the cause.

105
Views
0
Helpful
1
Replies