Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to limit bandwith per interface Vlan on trunk

Hi Guys, my question regarding QoS Police.

I have 7609 router (PE) connected via 1Gb fiber to 6524 switch(CE) using dot1Q trunk. The customer is having VlanA, VlanB & Vlan C.

The problem is I have to limit 100Mbps bandwidth for each Vlan on the PE-CE trunk. What command do I need to set on 7609 router? (assuming no additional command needed for CE)

1 REPLY

Re: How to limit bandwith per interface Vlan on trunk

Hi,

6500 switch and 7600 router , we can use a similar policy map to limit the traffic .

Create three class-maps for each customer and match the customer ip addresses in indivual class-maps

configure a policy-map and call the class-map to policy-map and police each class bandwidth to the requirement.

or create individual policy-map for each vlan

Apply the policy map to the Vlans .

Just a addition , configure " mls qos vlan-based " under the Gig interface

A link for ref:

http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a00801c8c4b.shtml#ios

hope it helps

regards

vanesh k

266
Views
0
Helpful
1
Replies
CreatePlease login to create content