Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

how to replace the rsp of C7507

hi.

Master rsp(slot2) of c7507 is rebooted because of crash.

currently, slave rsp is slot2

master rsp is slot3.

rsp of slot2 is hardware faulty

so i replace slot2 rsp.

i think below work order

1. slot3 rsp is removed.

2. slot3 rsp is moved at slot2 position.

3. new rsp is inserted at slot3

4. 7507 is rebooting

slot2 and slot3 image is using pcmcia card.

I would like know any configruation

what config is newly needed at

new rsp and old rsp

2 REPLIES

Re: how to replace the rsp of C7507

New Member

Re: how to replace the rsp of C7507

As long as both RSPs are equal, you only need to replace the RSP in slot 2. Slot 3 is up and active, you should remove the RSP in slot 2 and replace it with the new. They are hot swappable.

I keep my Config and IOS on PCMCIA cards and the boot variables set to the cards. Once the new processor is in slot two and the PCMCIA cards are in the appropriate card slot in the RSP, you should be all done. I had to do this a few months ago. We are running RPR+ for redundancy. There was no down time during this swap. You do not need to swap back to RSP 2 as your active unless you so choose. That's the beauty of this redundant processor router.

206
Views
0
Helpful
2
Replies
CreatePlease to create content