Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to reset default factory command on ASA ,Router and Switch

Dear All,

I would like to ask you about how to reset default factory on ASA,Router and Switch ( i mean it similar wr erase but if we do command wr erase all the command is gone, so i would like to original command on product.

Best Regards,

Rechard

2 REPLIES
New Member

Re: How to reset default factory command on ASA ,Router and Swit

The only way to reset the ASA to factory defaults is with the "wr era" command or the "clear configure" command.

If these commands are not available due to a password issue (ie can't remember the enable password) you will need to reset the passwords:

http://www.cisco.com/en/US/docs/security/asa/asa71/configuration/guide/trouble.html#wp1058131

Gold

Re: How to reset default factory command on ASA ,Router and Swit

ASA

conf t

configure factory-default

Router: I dont know if there is such a command.

might be depending on model of router and software version.

so wr er and then reload is the closest I know off

Switch:

I do not know of such a command, might exist depending on model and software version

so wr er and then do a reload is the closest I know of.

Good luck

HTH

1647
Views
0
Helpful
2
Replies
CreatePlease login to create content