Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

How to reset 'sh x25 route' match/use value?

Hi All,

on an X25 you can issue the 'show x25 route' command which can give you something like the following output:

r1#sh x25 route

# Match Substitute Route to match/use

0 dest ^4111(.*) Sub-dest \1 Serial1/0 1123/4

Now the question raised:

How can we reset the value for the output on match/use? Is it possible at all without rebbot of the router?

I haven't found any cmd which will do this up to now, also I was thinking about to 'clear' the routing table for X25, but also this seems not to be possible.

Any comment/help is welcome, thanks Thomas

294
Views
0
Helpful
0
Replies
CreatePlease to create content