I'm having trouble figuring out how to set up an AT&T OPTEMAN EVC in my home lab.
Routers r1, r2, and r3 are connected to r0 by way of the OPTEMAN circuit but they're also connected r1<->r2 and r2<->r3 by the same OPTEMAN circuit.
I'm imagining I can set up a layer 2 switch in place of the OPTEMAN circuit but I can't figure out how the switch would be set up. I thought if I made all the ports involved trunk ports this would work but it didn't. Then I started thinking perhaps I need to assign VLANs to some of the ports involved on the switch but I can only assign one VLAN per port and each router has at least 2 VLANs involved so that's not the solution.
Is it possible to set this up in a home lab? Thanks in advance.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.