Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to stop a command - make it stop running (such as ping)

Lets say I mess up and type 10000 instead of 1000 in an extended ping. Lets say I realize it only after the ping starts.

How do I make it stop?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: How to stop a command - make it stop running (such as ping)

Michael

Generally the ctl shift 6 combination will stop these commands.

HTH

Rick

9 REPLIES
Hall of Fame Super Silver

Re: How to stop a command - make it stop running (such as ping)

Michael

Generally the ctl shift 6 combination will stop these commands.

HTH

Rick

New Member

Re: How to stop a command - make it stop running (such as ping)

Thank you!

I have found I have to hit the CTRL-SHIFT-6 combo twice in rapid succession for it to work, but I am using Hyperterm, so who knows.

Thank you so very much, that is a great tip.

Hall of Fame Super Silver

Re: How to stop a command - make it stop running (such as ping)

Michael

I agree that hitting the key stroke combination several times seems to be necessary in many instances - including times when I am not using Hyperterm.

I am glad that my answer was helpful. Thank you for using the rating system to indicate that your question was resolved (and thanks for the rating). It makes the forum more useful when people can read a question and can know that they will read a response which resolved the question.

The forum is an excellent place to learn about Cisco networking. I encourage you to continue your participation in the forum.

HTH

Rick

Re: How to stop a command - make it stop running (such as ping)

Try this from the console.

hold down Ctrl+shift+6, release and then press x immediately. This may work depending on IOS

Regards,

Justin

Hall of Fame Super Silver

Re: How to stop a command - make it stop running (such as ping)

Justin

The keystroke combination you give is right if you want to suspend a telnet session. But to stop an executing command you do not need the x. A Ctrl+shift+6 is enough.

HTH

Rick

Re: How to stop a command - make it stop running (such as ping)

Thanks Rick, do you find it often do not work?

I often try to use this with no luck.

Justin.

Hall of Fame Super Silver

Re: How to stop a command - make it stop running (such as ping)

Justin

It may depend on what command you are trying to stop. I find that for ping and traceroute it is pretty effective (though it may take multiple entries of the key stroke combination). For other commands it may not be effective.

HTH

Rick

Re: How to stop a command - make it stop running (such as ping)

u can also set the break character by using "terminal escape-character Z" (I use z).

when I want to break a trace or oing, i simply hit z.

HTH

Sam

New Member

I have a Cisco ASA 5505 and I

I have a Cisco ASA 5505 and I just hit "q" to stop a task. 

76475
Views
20
Helpful
9
Replies