Hi, all
We have a CISCO 2811 router, and we have assigned the 69.65.187.124 to one interface, and 192.168.1.1 to another interface. Then we have configured the NAT-translate the http and https access of 69.65.187.124 to 80 and 443 port of 192.168.1.3(the Web server's IP address).
We have added another new web server, and we want to place it into another internal subnet (192.168.2.0/24),we want to access it through the new IP: 69.65.187.125, translate the http and https of 69.65.187.125 to 80 and 443 port of 192.168.2.3(the new web server's IP address).
We have purchased a HWIC-4ESW and installed it into the CISCO 2811, we have connected its one interface to the switch that is for the new subnet, and connected another interface to the firewall. How need we configure for the above request implementation? And we want that two subnets can communicate, how do we configure this? Does the CISCO have the simple configuration?
Thanks