Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

How to upload outputs other than running or startup config to ftp server?

Hi.I know how to upload the running or startup config to an ftp server but I was wondering If there Is a way to upload , lets say , the output of a sh ip int commmand ?

2 ACCEPTED SOLUTIONS

Accepted Solutions

Re: How to upload outputs other than running or startup config t

Hi,

   You might think of using the following commands.

Router#show ip interface brief | redirect flash:ShowInt.txt

   Then upload ShowInt.txt to where you want.

HTH,

Toshi

Hall of Fame Super Blue

How to upload outputs other than running or startup config to ft

One step method:

sh ip interface brief | redirect tftp:///filename.txt

3 REPLIES

Re: How to upload outputs other than running or startup config t

Hi,

   You might think of using the following commands.

Router#show ip interface brief | redirect flash:ShowInt.txt

   Then upload ShowInt.txt to where you want.

HTH,

Toshi

Community Member

Re: How to upload outputs other than running or startup config t

Thanks again!

Hall of Fame Super Blue

How to upload outputs other than running or startup config to ft

One step method:

sh ip interface brief | redirect tftp:///filename.txt

294
Views
0
Helpful
3
Replies
CreatePlease to create content