Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

how to use GUI interface

hi

pls tell me how to access gui interface of cisco 3845

1 REPLY

Re: how to use GUI interface

Hi

Is GUI (SDM) already installed on your PC?

If its there then just connect pc to g0/0,set pc to obtain IP from DHCP and type https://10.10.10.1 in your browser.

If not the pls refer following link for installating/troubleshooting sdm config.

http://www.cisco.com/univercd/cc/td/doc/product/software/sdm/sdmqsg/sdmq21.htm

Do come back in case you find it difficult, and indicate the problem

Regards

JDHi

Is GUI (SDM) already installed on your PC?

If its there then just connect pc to g0/0,set pc to obtain IP from DHCP and type https://10.10.10.1 in your browser.

If not the pls refer following link for installating/troubleshooting sdm config.

http://www.cisco.com/univercd/cc/td/doc/product/software/sdm/sdmqsg/sdmq21.htm

Do come back in case you find it difficult, and indicate the problem

Regards

JD

109
Views
0
Helpful
1
Replies
CreatePlease to create content