Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to use Offset-List in RIP for Back-up Route?

Assalam o Alaikum,

I have a network with redundant links. I want to have one as Primary and the other one as Backup. the configuration is attached with the diagram of network.

3 REPLIES

Re: How to use Offset-List in RIP for Back-up Route?

You need to create an access-list identifying the networks and then offset the metric out of that interface

for eg.

If you want 10.0.0.0/23 to be used as bakup over the VSAT connection, you need to d0 someting like this

access-list 10 permit 10.0.0.0 0.0.1.255

router rip

version 2

offset-list 10 out fastethernet 0/8

http://www.cisco.com/en/US/docs/ios/12_3/iproute/command/reference/ip2_o1g.html#wp1036466

HTH

Narayan

New Member

Re: How to use Offset-List in RIP for Back-up Route?

in which router???

Re: How to use Offset-List in RIP for Back-up Route?

If you choose out, then it should be on the branch switch

If you prefere using IN, then you need to use it on the router interface connecting to the switch

Narayan

183
Views
3
Helpful
3
Replies
CreatePlease to create content