Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

HSRP 3750-X Routing

My DC gives me two networks, a routing network /29 and a user network /28

x.x.x.1 – HSRP Gateway
x.x.x.2 – Edge Router 1
x.x.x.3 – Edge Router 2
x.x.x.4 – User
x.x.x.5 – User
x.x.x.6 – User

/28
x.x.x.100 – User
x.x.x.101 – User
x.x.x.102 – User
x.x.x.103 – User
x.x.x.105 – User
x.x.x.106 – User
x.x.x.107 – User
x.x.x.108 – User
x.x.x.109 – User
x.x.x.110 – User
x.x.x.111 – User
x.x.x.112 – User
x.x.x.113 – User
x.x.x.114 – User

Using a Cisco 3750-X (IP Base) what would be the best way to route between these? InterVlan routing? The /28 additional network is routed to "x.x.x.4 – User "

3 REPLIES
Hall of Fame Super Gold

Re: HSRP 3750-X Rourting

Using a Cisco 3750-X (IP Base) what would be the best way to route between these?

The new 12.2(55)SE IOS (IP Base feature set) supports RIPv1, RIPv2, IS-IS plus OSPFv1.

VIP Super Bronze

Re: HSRP 3750-X Rourting

Since this a small network with 3 devices and you only have IP Base IOS on the switch, static route or RIP ver2 works fine.

HTH

Reza

Community Member

Re: HSRP 3750-X Routing

So I create a Vlan for the Interface that connects to the DC and assign it a IP of x.x.x.4 then create a vlan for all of my servers and a static route to my DC gateway of x.x.x.1?

539
Views
0
Helpful
3
Replies
CreatePlease to create content