Hi.i have little problem.i have two 7606 wan edge routers.this two routers connect to wan routers over wan network.i have to configure tunnel interface for wan routers and 7606 routers becouse my wan conectivity in this way is provided with Vsat network.so h want to make this tunnel connection high available.so without any hsrp my tunnel source on 7606 side is one of my gig 1/4 ethernet interface that connects my 7606 to vsat modem and tunnel destination is gig 0/0 of wan router that is connected to vsat modem too.so is there any way that i configute hasrp on my gig ethernet on 7606 side and use high available ip address as a source of my tunnel interface on 7606 side (now tunnel source is gig 1/4)?? thanks...
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...