Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

HSRP Problem

Hi,

In our HSRP congiguration , we are facing one problem. We have formed HSRP

between two fast ethernet ports of 3845.

We are not tracking any interfaces. In normal operation I can see low priority ( 100 default ) router in standby mode and second router ( priority 150) as an active mode. When we physically remove gigabit port of second router , it still shows the active mode status and first jumps into active. We still get responce to the outside world via first router. Also after restoring gigabit port original condition is restored.

Any suggestions..

Thanks and Regards

Subodh Bapat

1 REPLY

Re: HSRP Problem

Dear,

Would you provide us with the output of Show Standby command from both routers.

Best Regards,

Mounir Mohamed

103
Views
0
Helpful
1
Replies
CreatePlease login to create content