I have a router that has the following configuration on one of the Eth interfaces:
ip address 10.10.24.15 255.255.252.0
ip helper-address 10.95.163.225
ip helper-address 10.95.195.226
ip pim sparse-dense-mode
standby 24 ip 10.10.24.1
standby 24 priority 90
However, the 10.10.24.1 isn't assigned on any of the other interfaces but I am able to ping it and telnet to it which connects me to the router. I am puzzled as where the 10.10.24.1 ip is, hich is assigned for the HSRP interface !
HSRP is enabled for this fast 2/0 interface. HSRP uses a mac-address in the form of 00-00-0c-07-ac-xx where xx is group 24 in hex. When this router interface uses hsrp and has a higher priority then its peers, then the hsrp ip is bound to this interface using a custom mac address.
Do a "show standby" and it will explain more about your config.
It is located on your router as a virtual interface.
Typically there would be a second router with a lower or higher priority that would be part of the router "pool".
Higher priority wins and all of the routers together would be seen as 10.10.24.1 by anything using them as a gateway.
If the highest priority router fails, the second highest priority takes over as 10.10.24.1 and none of the devices using the interface as a gateway, knows anything about the failure of the first router.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...