Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

HSRP VRRP combined together

Hello All,

I am a newbie i have a doubt regarding the HSRP and VRRP. Can these 2 be combined in a network,

i have one Cisco device(supports HSRP),

Cisco Catalyst 6000 Series Switches Module Switch Feature Card (MSFC) and one

Juniper(supports VRRP), Juniper M-20 Router is it possible to have the same virtual IP configured for both these devices.

Thanks in advance.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: HSRP VRRP combined together

see HSRP is the cisco propritery protocol, so you can use it when you are having cisco devices... and VRRP is the open standard which can be run on any manufacture device... so when ever you are having one device from cisco and other is form other manufacturer then you must have to go for VRRP...

hope this will help you

rate this post if it helps

regards

Devang

3 REPLIES
Silver

Re: HSRP VRRP combined together

Hello Netneo,

HSRP and VRRP are in no way compatible as the protocol mechanics differ greatly. I suggest to configure VRRP on the Cisco router which is available in Cisco IOS software and thus can speak with your Juniper router.

HTH

--Leon

* Please rate posts.

Community Member

Re: HSRP VRRP combined together

Thanks Leon for the reply, it has reolved my issue.

Re: HSRP VRRP combined together

see HSRP is the cisco propritery protocol, so you can use it when you are having cisco devices... and VRRP is the open standard which can be run on any manufacture device... so when ever you are having one device from cisco and other is form other manufacturer then you must have to go for VRRP...

hope this will help you

rate this post if it helps

regards

Devang

1149
Views
5
Helpful
3
Replies
CreatePlease to create content