Everyting is configured on the lan or ethernet interface with standby commands. The routers are considered to be in a standby group or groups depending on your needs. The unique standby ip address is the default gateway address advertised by all routers in that group. The router with the highest priority is considered the ACTIVE Router while the all other routers in the group are considered STANDBY. Default priority 100, therefore you assign your primary router a higher number to make it the ACTIVE Router. You can track an interface optionally. If the router hardware or interface you track should fail Active router goes to standby and a standby with the next highest priority goes to active. You need a separate Wan line for each router.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...