We've loaded a Cisco SAN switch into an IBM mainframe and are trying to telnet into the web management console. But all that's appearing is a 404 web error. When i simulate it in our lab everythings fine.
Just wondering if there are any opinions. Sorry to be so vague, but that's all the details i've got at the moment. I've told the on-site engineer to reload the switch, but i'm not actually sure that this will do anything apart from wipe the current configuration off of the switch.
The 404 or Not Found error message is a HTTP standard response code indicating that the client was able to communicate with the server but either the server could not find what was requested, or it was configured not to fulfill the request and not reveal the reason why. 404 errors should not be confused with "server not found" or similar errors, in which a connection to the destination server cannot be made at all.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...