I'm changing my internet gateway router from cisco 2600 to Cisco 2811 router but I have problems access the https servers on the DMZ of my PIX firewall which is behind the internet gateway router. What could be responsible?.
the firewall featureset on the 2811 is not enbled yet. The 2811 is running exactly the same configuration as the old 2600 router. I will like to know if some configs are enbled on the 2811 router by default that blocks https?.
I believe that Atif is quite correct that nothing is enabled by default that would affect normal routing operation. Perhaps the original poster can post the config of the router and that would give us a starting point to determine what is the problem.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...