HTTPS ACCESS THROUGH Cisco 2811 Router

[o.oresotu]

Hi,

I'm changing my internet gateway router from cisco 2600 to Cisco 2811 router but I have problems access the https servers on the DMZ of my PIX firewall which is behind the internet gateway router. What could be responsible?.

[atif.awan]

Any access-lists on the 2811 router? Are you running the 2811 with a firewall featureset with firewalling enabled? Have you made sure that your configuration on 2811 matches that of your old 2600?

[o.oresotu]

the firewall featureset on the 2811 is not enbled yet. The 2811 is running exactly the same configuration as the old 2600 router. I will like to know if some configs are enbled on the 2811 router by default that blocks https?.

[atif.awan]

Nope there is nothing enabled by default that can affect normal routing operation.

[Richard Burts]

I believe that Atif is quite correct that nothing is enabled by default that would affect normal routing operation. Perhaps the original poster can post the config of the router and that would give us a starting point to determine what is the problem.

HTH

Rick