Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

HWIC-1FE as trunk

I am not able to configure HWIC-1FE as a trunk port.However the switchport command is not available in its interface configuration mode.

any suggestions?

1 REPLY

Re: HWIC-1FE as trunk

Hello!

HWIC-1FE is a router interface.In which device are you using it? You cannot configure a L3 port with swichport command.

Use subinterface on that module with "encapsulation dot1q 'vlan_number'" where the vlan_number is configured on the switch (if you connect the router to a switch) and allowed by the trunk config.

Please tell me if you understand or give more details.

Good luck!

Calin

246
Views
0
Helpful
1
Replies
CreatePlease to create content