I have a 1841 with a 2SHDSL wic, testing using a BT SDSL circuit which works fine on a Cisco 878 router.
When I plug the same circuit into the SHDSL interface using the standard straight through cable which come with the 878 I am having issues with the DSL state transisioning from DSL UP to DSL DOWN and the light on L0 intermiently flashing. The atm pvc is established, but the virtual access interface has line up but line protocol down. The config of the controller is below I have a feeling the issue is with the cabling.
Has anyone come across this before or any suggestions would be welcome.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...