Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

HWIC-3G-GSM cannot connect to internet

Hi,

I have configured a HWIC-3G-GSM router to connect to internet, and to install VPN eventually.

The router is able to get an IP address from Service Provider, but when i ping that IP address from the router, the ping failed. I am not able to any other public IP from the router.

Attached is the configuration from show run and show cell 0/0/0 all. Please ignore showrun.txt, showrun1.txt is valid.

Also

yourname#sho int dialer0
Dialer0 is up, line protocol is up (spoofing)
  Hardware is Unknown
  Internet address is 123.209.133.155/32
  MTU 1500 bytes, BW 56 Kbit/sec, DLY 20000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation PPP, loopback not set
  Keepalive set (10 sec)
  DTR is pulsed for 1 seconds on reset
  Interface is bound to Ce0/0/0
  Last input never, output never, output hang never
  Last clearing of "show interface" counters 00:26:36
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: weighted fair
  Output queue: 20/1000/64/0 (size/max total/threshold/drops)
     Conversations  1/1/16 (active/max active/max total)
     Reserved Conversations 0/0 (allocated/max allocated)
     Available Bandwidth 42 kilobits/sec
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     4 packets input, 244 bytes
     29 packets output, 2769 bytes
Bound to:
Cellular0/0/0 is up, line protocol is up
  Hardware is HSDPA/UMTS/EDGE/GPRS-850/900/1800/1900/2100MHz
  MTU 1500 bytes, BW 384 Kbit/sec, DLY 20000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation PPP, LCP Open
  Open: IPCP, loopback not set
  Keepalive not supported
  Interface is bound to Di0 (Encapsulation PPP)
  Last input 00:11:18, output 00:11:18, output hang never
  Last clearing of "show interface" counters never
  Input queue: 1/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: weighted fair
  Output queue: 0/1000/64/0 (size/max total/threshold/drops)
     Conversations  0/1/16 (active/max active/max total)
     Reserved Conversations 0/0 (allocated/max allocated)
     Available Bandwidth 288 kilobits/sec
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     14 packets input, 418 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
     17 packets output, 886 bytes, 0 underruns
     0 output errors, 0 collisions, 1 interface resets
     0 unknown protocol drops
     0 output buffer failures, 0 output buffers swapped out
     0 carrier transitions
     DCD=up  DSR=up  DTR=up  RTS=up  CTS=up

please help why i can get traffic outside. Thanks

peiwai

1 REPLY
New Member

Re: HWIC-3G-GSM cannot connect to internet

Eventually, i was able to ping the internet from the router, without having to change the attached configurations.

But PC in the internal network (10.10.10.x ) is not able to go out the internet.

Please advise what configuration is needed so internal PC can connect to internet.

488
Views
0
Helpful
1
Replies